Zanussi ZDC8203W Condenser Tumble Dryer Heating Element Not Working

January 11, 2025

Hello. I’ve watched your various videos on the above. Very good thank you. I have a Zanussi ZDC8203W Condenser Tumble Dryer.The mains power is reaching the heater unit and checked across both connectors with m/meter and it’s 240. There is no continuity beep however across the terminals when the mains connectors are removed. Does this mean the element itself needs replacing. If so do you supply these?Sorry I’m not sure how to upload a vid to YouTube but can send a photo if that’s possibleThanksNeil

I will try and help with this problem about Zanussi ZDC8203W Condenser Tumble Dryer,

Hi Neil, thanks for your question about your Zanussi tumble dryer not heating. I've got the workshop manual and wiring diagram for you. These will explain how to test the heating element.

The heating element usually has one or two circuits for high and low heat. There is a cut-off thermostat on the back of the heating element, which might be covered. This thermostat can also become an open circuit.

To test the element properly, you need to take it out and check if both high and low fields have continuity. You can use an Ohm's law calculator to measure it in ohms and understand the wattage. It's a simple job and easy to replace.

There is a video above to help you replace it, and the wiring diagrams show the complete wiring circuit for the machine. I hope this information helps you. There is also a full list of parts at the top of the page. Good luck with your repair!

If you want to support the site please mark us to your favourites, also I would be grateful if you would subscribe to our social media channels as this really helps my site and keeps us going.

YouTube. http://www.youtube.com/user/howtorepair
Facebook. https://www.facebook.com/how.to.repair.appliances
And if we really helped you save money you can always click on the Buy Paul a Beer page